Copper mask for maintenance and cleaning methods you really understand?
The outer layer of the often built up a lot of outside dust, bacteria and other contaminants in the air, and the inner block out bacteria, saliva, therefore, the two sides cannot be used interchangeably, otherwise will outer dirt stained in direct clingy facial when inhaled, and become a source of infection.
The masks in don't wear, should be folded into a clean inside the envelope, and will be close to the nose and mouth folded in a face, avoid by all means literally into a pocket or hanging around his neck.
If is breathed out hot or wet saliva, its effect in blocking bacteria could be greatly reduced.
So, usually best for more a few masks, used to replace, should change once a day.
When washing should be blanching for 5 minutes.
Particular way is: 1, first wash with warm water and soap gently knead gauze masks, cup mask can dip in with soft brush brush gently detergent net, then wash clean.
Please note that do not forcibly knead, because if the gauze fabric clearance is too large lost prevention droplets.
2, disinfection will wash clean masks in 2% acetic acid peroxide solution soak for 30 minutes in boiling water for 20 minutes or in boiler steam for 15 minutes, and then to dry and set aside.
This method is suitable for the gauze masks and cup mask.
3, check again before use, should carefully check the mask and helmet is still in good condition, for gauze masks and mask can take pervious to light control method, the former care to get the lamp, see if there are any obvious spot, and edges in the middle of light transmittance is consistent, if in doubt will replace a new one.
Whatever you do, mask and mask generally will be updated after cleaning 3 to 7 times, particularly good quality masks can clean 10 times.
Activated carbon adsorption masks should pay attention to regular replacement of activated carbon sandwich, cannot be replaced if activated carbon interlining, used 7 to 14 days to be replaced, this mask is not repeat use after cleaning.
Masks should follow what elements of choose and buy, should pay attention to what the characteristics of the Labour protection glove of cycling gloves
Most places have a few choices when it comes to copper fabric clothing
antibacterial clothing distributors, but it can sometimes be difficult to find the right supplier for your needs. The quality of antibacterial clothing is critical to copper fabric clothing.
And finally, if you want to find additional resources for antibacterial clothing, simply go to Copper Plus Mask for more.
The same determination is critical for business owners. The journey in antibacterial clothing business is both a challenging and rewarding experience.