One-Stop Solution Service Provider for all kind of Healthy Functional Copper Mask, Antibacterial Mask, Copper Infused Face Mask Products.

     

How to clean industrial protective masks

by:Copper Plus     2021-05-24
There are various types of industrial protective masks, and the selection must be based on different job requirements and working conditions. The editor of the following industrial protective copper mask manufacturers will introduce to you: The outer layer of industrial protective masks often accumulates a lot of dust, bacteria and other dirt in the outside air, while the inner layer blocks the exhaled bacteria and saliva. Therefore, the two sides cannot be alternated. If it is used, otherwise the dirt on the outer layer will be inhaled into the human body when it is directly attached to the face and become a source of infection. When the mask is not worn, it should be folded into a clean envelope, and the side close to the nose and mouth should be folded inward. Don't just put it in your pocket or hang it around your neck.   If the industrial protective copper mask is wetted by exhaled heat or saliva, its function of blocking germs will be greatly reduced. Therefore, prepare as many masks as possible at ordinary times so that they can be replaced. They should be changed and washed once a day. When washing, it should be scalded with boiling water for 5 minutes.  Industrial protective masks should be cleaned and disinfected every day. Both gauze masks and air filter masks can be disinfected by heating. The specific method is:    cleaning. First rub the gauze mask gently with warm water and soap. The bowl-shaped copper mask can be gently cleaned with a soft brush dipped in detergent, and then rinsed with clean water. Please be careful not to rub it hard, because if the warp and weft gap of the gauze is too large, it will lose its anti-dropping effect. disinfect. Soak the cleaned mask in a 2% peroxy-2 acid solution for 30 minutes or boil it in boiling water for 20 minutes or steam it in a steamer for 15 minutes, and then dry it for later use. This method is suitable for gauze masks and bowl-shaped masks. an examination. Before using again, you should carefully check whether the masks and face shields are still intact. For gauze masks and face shields, you can take the light transmission method, that is, take the light in front of the lamp to see if there are obvious light spots. The middle part and the edge part are transparent. Is the rate consistent? If in doubt, replace it with a new one. In any case, face masks and masks are usually updated after 3 to 7 cleanings, and masks of particularly good quality can be cleaned 10 times. Activated carbon adsorption masks should pay attention to regular replacement of the activated carbon interlayer. If the activated carbon interlayer is not replaceable, it must be replaced after 7 to 14 days. This type of mask cannot be reused after cleaning.   The above is how to clean industrial protective masks introduced by the editor. I hope to help you! 369
The use and installation of antibacterial clothing is compared with most other systems for managing the copper fabric clothing effectively and no doubt antibacterial clothing have won the race so many times.
Exceed customers' expectations in the procedures of manufacturing antibacterial clothing.
antibacterial clothing has a very good repute over the global market.
On top of making sure all our day-to-day operations are running smoothly, Harvest SPF Textile Co., Ltd. needs to ensure that we're keeping up with all the quality standards of antibacterial clothing.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...